1. Install the footswitch so that the metal washer is inside the enclosure and the plastic
washer is on the outside.  Use a 14mm wrench to tighten.

2.  Install the 1/4" jacks so that when you are looking into the enclosure, the stereo (IN) jack
is on the left and the mono (out) jack is on the right.  Turn them so the solder lugs are facing
up.  Use a 1/2" wrench to tighten

3.  Install the potentiometers so that the solder lugs are pointing up.  This will occur naturally
because of the stabilizing knotches.  Put the b100k on the left, the b25k in the middle and the
a500k on the right.  Use an 11mm wrench to tighten.  Do not over tighten these.  Snug is
good enough.

4.  Install the AC adaptor jack.  Turn it so the positive solder lugs are facing up.  Use a 14mm
wrince to tighten.

5.  Install the LED bezel.  The split washer should be on the inside of the enclosure.  Use a
10mm wrench to tighten.